The door should stop and reverse direction within 2 seconds to the fully open position when it contacts the board.Close the garage door using the wall control.With the garage door open, lay a 2 by 4 board flat on the floor at the center of the door opening.Press and release the wall control button and allow the garage door to travel and stop at the UP limit.Press and release the wall control button and allow the garage door to travel and stop at the DOWN limit.The door must complete one full cycle before the settings are automatically recorded. The force controls are set automatically when the wall control is used for the first time with a garage door opener. Both LEDs will flash blue then go out.įorce control refers to how much power is needed to open/close a particular door and doesn’t require programming. Then, press and release the SET/PRGM button.Adjust open travel as necessary using both UP and DOWN buttons. If the door opens too far use the DOWN arrow button. Press and hold the UP arrow button until the door is fully open.Press and release the SET/PRGM button.Use both UP and Down buttons to adjust close travel as necessary. If the door closes too far, use the UP arrow button. Press and hold the DOWN arrow button until the door is fully closed.Follow these steps to set the down limit: Travel limit refers to a programmable setting to adjust how far the door travels up or down. Remote Control Programming (remote controls included with the opener come programmed from the factory).The order of programming the opener’s functional settings and install any accessories should strictly be as follows: Do not start with the door fully open or closed. The door should rest somewhere between full open and closed.The door must be locked to the opener prior to programming.Check to make sure that there are no objects in the garage door opening.How to Program Genie Garage Door Openerīefore programming the opener, there are several important things to note: If you are having trouble with your Genie garage door opener, here is an easy-to-follow troubleshooting guide, with steps to take you through some of the common issues with this device. However, programming or reprogramming the remote or wireless keypad can prove challenging. Genie garage door openers are known for their convenience and simple-to-use intellicode remote controls.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |